In-Band Management Interface
JDM has an interface—jsxe0—that can be used as in-band management interface. Unlike
the out-of-band management interface jmgmt0, this interface is not directly connected
to a physical port. You must connect jsxe0 to a physical interface through VLAN
bridging—that is, you must configure both the physical interface and jsxe0 to be in the
same management VLAN.
Figure 10 on page 33 illustrates how a network port is bridged to jsxe0. In this figure,
ge-0/0/0 is the network port being used for in-band management. Interface sxe-0/0/0
is a JCP interface. Both ge-0/0/0 and sxe-0/0/0 are managed by JCP, and are configured
in JCP to be part of the management VLAN, mgmt-vlan. JDM interface jsxe0 is also
configured to part of the mgmt-vlan.
Figure 10: In-Band Management Interface Network
Junos
Control Plane
(JCP)
Configuration
WAN
BCM
g043473
Juniper
Device Manager
(JDM)
jsxe0
sxe-0/0/0ge-0/0/0
mgmt-VLAN traffic
mgmt-VLAN
traffic
OVS-DPDK
NIC port
hsxe0
mgmt-VLAN System Bridge
Related
Documentation
Configuring the In-Band Management Interface for JDM on page 35•
• Understanding JDM Management Interfaces on page 32
Configuring the Out-of-Band Management Interface for JDM
This topic discusses how to configure an out-of-band management interface for JDM in
a disaggregated Junos OS platform.
On a disaggregated Junos OS platform, the out-of-band management interface for JDM
is named mgmt0. The mgmt0 interface has a direct connection to the dedicated Ethernet
management port on the front panel of the device.
•
Configuring the Out-of-Band Management Interface with IPv4 Addressing for
JDM on page 34
•
Configuring the Out-of-Band Management Interface with IPv6 Addressing for
JDM on page 34
33Copyright © 2017, Juniper Networks, Inc.
Chapter 3: Management
To Next Page
Loading...
