Juniper NFX250 - Configuring SNMP on JDM; Configuring SNMP Community; Configuring SNMP System Parameters

• Accessing the JDM Shell, JDM CLI, and JCP Prompts in a Disaggregated Junos OS
Platform on page 28
Configuring SNMP on JDM
There are several SNMP-enabled components in NFX (JDM, hypervisor, and so on). This
topic discusses the SNMP implementation of JDM and hypervisor. For JCP, see the Junos
documentation. On the NFX250 platform, JDM plays the role of the SNMP agent and at
the same time it acts as an SNMP proxy for the hypervisor (host OS). When SNMP is
configured in JDM, hypervisor also takes the same SNMP configuration. By default, SNMP
is disabled on disaggregated Junos OS platforms. To enable SNMP , you must include
the SNMP configuration statements at the [edit snmp] hierarchy level. This section
describes:
•
Configuring SNMP Community on page 39
•
Configuring SNMP System Parameters on page 39
•
Configuring SNMP v3 on page 40
•
Configuring SNMP Traps on page 40
•
Querying SNMP MIBs on page 40
•
Managing Traps on page 41
Configuring SNMP Community
To configure SNMP community:
1. Specify a name for the SNMP community:
user@jdm# set snmp community community
Configuring SNMP System Parameters
To configure SNMP system parameters:
1. Set the system name:
user@jdm# set snmp name name
2. Enter a description for the system being managed:
user@jdm# set snmp description description
3. Specify the location of the system:
user@jdm# set snmp location location
4. Specify the name of the contact person:
user@jdm# set snmp contact contact
39Copyright © 2017, Juniper Networks, Inc.
Chapter 3: Management