Juniper SRX340 Hardware Guide

CHAPTER 21
Overview of Replacing Components
•
SRX340 Services Gateway Field Replaceable Units Overview on page 87
•
Required Tools and Parts for Replacing the SRX340 Services Gateway
Components on page 87
SRX340 Services Gateway Field Replaceable Units Overview
Field-replaceable units (FRUs) are components that you can replace at your site. The
Mini-Physical Interface Module (MPIM) is the only FRU on the SRX340 Services Gateway.
The Mini-PIMs are not hot-swappable. You must power off the services gateway before
removing or installing Mini-PIMs.
Related
Documentation
Required Tools and Parts for Replacing the SRX340 Services Gateway Components
on page 87
•
• Replacing Mini-Physical Interface Modules in the SRX340 Services Gateway on page 89
Required Tools and Parts for Replacing the SRX340 Services Gateway Components
The following tools and parts are required for replacing a Mini-Physical Interface Module
(MPIM) on the services gateway:
•
Electrostatic bag or antistatic mat, for each component
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade (–) screwdriver, approximately 1/8 in. (3 mm)
•
Phillips (+) screwdriver, number 1
•
Blank panels (if no component will be installed)
Related
Documentation
• Replacing Mini-Physical Interface Modules in the SRX340 Services Gateway on page 89
87Copyright © 2016, Juniper Networks, Inc.

Juniper SRX340 Specifications

General

Firewall Throughput	3 Gbps
Maximum Concurrent Sessions	256, 000
Memory	4 GB
Redundant Power Supplies	No
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% non-condensing
Storage	8 GB