Preventing Electrostatic Discharge Damage to the SRX340 Services Gateway
Many services gateway hardware components are sensitive to damage from static
electricity. Some components can be impaired by voltages as low as 30 V. You can easily
generate potentially damaging static voltages whenever you handle plastic or foam
packing material or if you move components across plastic or carpets. Observe the
following guidelines to minimize the potential for electrostatic discharge (ESD) damage,
which can cause intermittent or complete component failures:
•
Always use an ESD wrist strap or ankle strap, and verify that it is in direct contact with
your skin.
CAUTION: For safety, periodically check the resistance value of the ESD
strap. The resistance must be in the range of 1 to 10 Mohm.
•
When handling any component that is removed from the chassis, verify that the
equipment end of your ESD strap is attached to one of the ESD points on the chassis.
•
Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can damage components.
•
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag. See
Figure 13 on page 107. If you are returning a component, place it into an electrostatic
bag before packing it.
Figure 13: Placing a Component into an Electrostatic Bag
Related
Documentation
• SRX340 Services Gateway Definition of Safety Warning Levels on page 101
• SRX340 Services Gateway General Safety Guidelines and Warnings on page 103
• SRX340 Services Gateway Safety Requirements, Warnings, and Guidelines on page 104
• Restricted Access Area Warning on page 104
• Qualified Personnel Warning on page 106
107Copyright © 2016, Juniper Networks, Inc.
Chapter 24: General Safety Guidelines and Warnings
To Next Page
Loading...
Need help?
General
