Juniper SRX340 Hardware Guide

CHAPTER 11
Installation Overview
•
SRX340 Services Gateway Installation Overview on page 43
•
Required Tools and Parts for Installing the SRX340 Services Gateway on page 43
•
SRX340 Services Gateway Autoinstallation Overview on page 44
SRX340 Services Gateway Installation Overview
After you have prepared the site for installation and unpacked the SRX340 Services
Gateway, you are ready to install the device. It is important to proceed through the
installation process in the following order:
1. Review the safety guidelines explained in “General Electrical Safety Guidelines and
Warnings” on page 121.
2. Prepare the services gateway for installation as described in “Preparing the SRX340
Services Gateway for Rack-Mount Installation” on page 49.
3. Install the services gateway as described in “Installing the SRX340 Services Gateway
in a Rack” on page 51.
4. Connect cables to external devices.
5. Connect the grounding cable as described in “Connecting the SRX340 Services
Gateway Grounding Cable” on page 54.
6. Power on the services gateway as described in “Powering On the SRX340 Services
Gateway” on page 60.
Related
Documentation
Required Tools and Parts for Installing the SRX340 Services Gateway on page 43•
• SRX340 Services Gateway Autoinstallation Overview on page 44
Required Tools and Parts for Installing the SRX340 Services Gateway
To install the services gateway, you need the following tools and parts:
•
Phillips (+) screwdriver, number 2
•
Tie-wrap
•
Electrostatic discharge (ESD) grounding wrist strap
43Copyright © 2016, Juniper Networks, Inc.

Juniper SRX340 Specifications

General

Firewall Throughput	3 Gbps
Maximum Concurrent Sessions	256, 000
Memory	4 GB
Redundant Power Supplies	No
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% non-condensing
Storage	8 GB