Juniper SRX340 - RS-422449 (EIA-449) DCE Cable Pinouts for the 1-Port Serial Mini-Physical Interface Module

CHAPTER 18
Performing the Initial Configuration
•
SRX340 Services Gateway Software Configuration Overview on page 63
•
Understanding SRX340 Services Gateway Factory-Default Settings on page 64
•
Viewing SRX340 Services Gateway Factory-Default Settings on page 64
•
Accessing J-Web on the SRX340 Services Gateway on page 66
•
Configuring the SRX340 Services Gateway Using the J-Web Setup Wizard on page 67
•
Accessing the CLI on the SRX340 Services Gateway on page 69
•
Connecting to the SRX340 Services Gateway from the CLI Remotely on page 71
•
Configuring the SRX340 Services Gateway Using the CLI on page 71
SRX340 Services Gateway Software Configuration Overview
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled and ready to be configured when the device is powered on. You can
perform the initial software configuration of the services gateway by using the
browser-based setup wizard or by using the command-line interface (CLI).
Before configuring the device, gather the configuration information required to deploy
the device in your network. At a minimum, the setup wizard requires the following
information:
•
Device name
•
Password for the root user
•
Management interface
•
Time information for the services gateway location
Related
Documentation
Understanding SRX340 Services Gateway Factory-Default Settings on page 64•
• Viewing SRX340 Services Gateway Factory-Default Settings on page 64
• Accessing J-Web on the SRX340 Services Gateway on page 66
• Configuring the SRX340 Services Gateway Using the J-Web Setup Wizard on page 67
• Accessing the CLI on the SRX340 Services Gateway on page 69
• Connecting to the SRX340 Services Gateway from the CLI Remotely on page 71
63Copyright © 2016, Juniper Networks, Inc.