Juniper SRX340 Hardware Guide

is assigned to the device. You can use the ipconfig (or ifconfig for Macintosh or Linux
users) command to verify the IP address.
3. Open a Web browser on the management device and enter the IP address
http://192.168.1.1 in the address field.
Related
Documentation
SRX340 Services Gateway Software Configuration Overview on page 63•
• Understanding SRX340 Services Gateway Factory-Default Settings on page 64
• Viewing SRX340 Services Gateway Factory-Default Settings on page 64
• Configuring the SRX340 Services Gateway Using the J-Web Setup Wizard on page 67
• Accessing the CLI on the SRX340 Services Gateway on page 69
• Connecting to the SRX340 Services Gateway from the CLI Remotely on page 71
• Configuring the SRX340 Services Gateway Using the CLI on page 71
Configuring the SRX340 Services Gateway Using the J-Web Setup Wizard
This topic describes how to perform the initial software configuration of your services
gateway using the setup wizard.
This topic includes the following sections:
•
About the Setup Wizard on page 67
•
About the Default Setup Mode on page 68
•
About the Guided Setup Mode on page 68
About the Setup Wizard
The setup wizard guides you through the step-by-step configuration of a services gateway
that can securely pass traffic. To help guide you through the process, the wizard:
•
Provides recommended settings based on your previous selections. For example, the
wizard recommends security policies based on the security topology you have defined.
•
Determines which configuration tasks to present to you based on your selections.
•
Flags any missing required configuration when you attempt to leave a page.
•
Indicates which configuration elements or tasks are unavailable to you based on your
previous selections by graying them out.
You can choose one of the following setup modes to configure the services gateway:
•
Default Setup mode—This mode allows you to quickly set up a services gateway in a
default security configuration. In this mode, you can configure basic system settings,
such as the administrator password, and download purchased licenses. Any additional
configuration can be carried out after completing the wizard setup.
•
Guided Setup mode—This mode allows you to set up a services gateway in a custom
security configuration.
67Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Performing the Initial Configuration

Juniper SRX340 Specifications

General

Firewall Throughput	3 Gbps
Maximum Concurrent Sessions	256, 000
Memory	4 GB
Redundant Power Supplies	No
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% non-condensing
Storage	8 GB