10. Configure an IP address on the 192.168.1.0/24 subnetwork for the management device.
By default, the management interface is configured with the 192.168.1.1/24 IP address.
If you need to change the IP address, perform the following steps or else proceed to
11.
a. Delete the default management interface IP address:
root# delete interface fxp0 unit 0 family inet address 192.168.1.1/24
b. Configure a new IP address for the management interface:
root# set interfaces fxp0 unit 0 family inet address address/prefix-length
c. Commit the configuration changes.
root# commit
d. Configure an IP address for the management device. Ensure that the IP address is
on the same subnetwork as the management interface (fxp0).
11. Launcha Web browser from the managementdeviceand access the services gateway
using the URL https://192.168.1.1.
If you changed the management interface IP address in 10, then use the URL
https://<management IP address> to access the services gateway.
NOTE: As the system-generated certificate is not trusted by default, an
alert is displayed. You can ignore this alert and proceed to access the
services gateway.
The J-Web login page is displayed. This indicates that you have successfully completed
the initial configuration and that your services gateway is ready for use.
NOTE: To access the J-Web interface, your management device requires
one of the following supported browsers:
•
Microsoft Internet Explorer version 9.0 or 10.0
•
Mozilla Firefox version 38 (or later)
12. Log in as root and proceed with configuring the settings based on your requirements.
Related
Documentation
• SRX4100 Services Gateway Factory-Default Settings on page 53
• Viewing Factory-Default Settings on page 54
• Connecting the SRX4100 Services Gateway to a Management Console on page 51
Copyright © 2017, Juniper Networks, Inc.56
SRX4100 Services Gateway Hardware Guide
To Next Page
Loading...
