K&R ACD320 Series - Page 50

ACD320user manual Function parameters list
- 45-
F3.11
The fault before
previous fault type
0：No fault
1: IGBT module protection
2: Acceleration over-current
3: Deceleration over-current
4: Constant speed over-current
5: Acceleration over-voltage
6: Deceleration over-voltage
7: Constant speed over-voltage
8: Control power fault（Stop over-voltage）
9: Operation under-voltage fault
10: Inverter overload
11: Motor overload
12: Input side phase failure
13: Output side phase failure
14: Inverter overhea
15: External fault
16:RS485 communication fault
17:Reserved
18: Current detect error
19: Motor self-learning error
20:Reserved
21: EEPROM operation error
22: hardware fault
23: short-current fault
25: PID feedback disconnect er ror
26:Water-lack protection failure
27：the inverter operation time reached
0 * 89
F3.12 Previous fault type 0 * 90
F3.13 Current fault type 0 * 91
F3.14
Operating
frequency at current
fault
0.00～600.00Hz 0．00Hz * 92
F3.15
Output amperage at
current faul t
0.0～2000.0A 0.0A * 93
F3.16
Bus voltage at
current fault
0.0～1000.0V 0.0V * 94
F3.17 Reserved 0 ○ 95
F3.18 Reserved 0 ○ 96
F4 Application Function Parameters
F4.00 ACCELTime2 0.1～3600.0s 10.0s ○ 97
F4.01 DECELTime2 0.1～3600.0s 10.0s ○ 98
F4.02
Frequency of Jog
running
0.00～F0.04 5.00Hz ○ 99
F4.03
The acceleration
time of JOG
running
0.1～3600.0s 10.0s ○ 100