254
DG - Diagnostics Parameters (Combivis only)
Value: Description:
96 Abnormal Stop Drive Overheat
97 Abnormal Stop Motor Protection
98 No Abnormal Stop Overload
99 Abnormal Stop Overload
100 Abnormal Stop Overload 2
101 No Abnormal Stop Overload 2
102 Abnormal Stop Set
103 Abnormal Stop Bus Synchronization
104 Abnormal Stop Software Limit Forward
105 Abnormal Stop Software Limit Reverse
106 Abnormal Stop Maximum Acceleration
107 Abnormal Stop Speed Control Limit
121 Ready for Positioning
122 Positioning Active
123 Position Not Accessible
124 Protection Rotation Forward
125 Protection Rotation Reverse
126 Position Not Accessible Ignored
127 Calculate Motor Data Complete
128 Reference Found
132 STO Switched Off
150 Main Contact Failure
151 Brake Switch Failure
152 Speed Following Error
153 Speed Selection Error
154 ETS Input Failure
155 ETS Overspeed
156 NTS Input Failure
157 Analog Signal Failure
158 Unintended Movement
159 Secure Fault Reset
160 ESD Input Failure
161 Direction Selection Failure
162 Drive Enabled Switched Off
163 Error Field Bus Watchdog
164 Error Commutation Position
165 Error Excessive Acceleration
166 Error Serial Command Speed
170 UPS Mode
171 Reduced Torque
To Next Page
Loading...
Need help?
General
