FILTER PROG.CHANGE RX
From the first screen of the MIDI menu, by pressing
the F7 button a window will appear where to set the
Program Change reception filter (Figure 220). By
using the buttons F1-10 you can select the parts to
filter:
F1–Right
F2–Left
F3–Bass
F4–Drums
F5–ALL PARTS
F6–Global (global channel of the keyboard)
F7–Registration
F8–Voicetron
F9–ARRANGER CHORDS (opens another window)
F10–VOICE/DRAWBAR (opens another window)
Select the MIDI reception filter options by using
the CURSOR
§ ¶
buttons
or the DATA/VALUE
wheel. Press the CURSOR Ó Á
buttons
to set the
“FILTERED” value to activate the filter, or the “—”
value to deactivate the filter. The filter options are the
following (Figure 220, 221, 222):
TRANPOSE RX
From the first screen of the MIDI menu, by pressing
the F3 button a window will appear where to set the
MIDI reception of the parts transposition. By using the
F1-F10 buttons or the CURSOR
§ ¶
buttons
you
can select the parts to transpose via MIDI reception,
as shown in Figure 223
. By using the CURSOR Ó Á
but
tons
or the DATA/VALUE wheel you can assign
+/- 36 semitones transposition value in 1 semitone
steps. By pressing the CURSOR Ó Á together you
set the default value “—”, that is no transposition.
F1–Right
F2–Left
F3–Bass
F4–Lower1
F5–Lower2
F6–Chord1
F7–Chord2
F8–Chord3
F9–Chord4
F10–Chord5
Figure 220
Figure 221
Figure 222
Figure 223
Exclusive Msg
Tabs Exc. Msg
Program Change
AFTERTOUCH
PITCH BEND
All Controls
All RPN
All NRPN
MODULATION
VOLUME
REVERB
Chorus/Effect
Pan Pot
EXPRESSION
Sust./Soft/Sost.
PORTAMENTO
WHA
Mono/Poly
ADSR
CUTOFF
RESONANCE
GM/GS Reset
Reset All Controls
Arabic Scale
To Next Page
Loading...
