88 | 08 GM and Drum Restyle
PART VIEW
This page appears after selecting one of the 16 tracks and pressing the PART VIEW button:
• PART 1, PART 2, up to PART 16: Select this button and turn the data knob to move
from one MIDI track to the next.
• MODE: Assigns a category to the track among the following values
o VOICE: normal instrument track.
o DRUM: rhythm track.
o GROOVE: groove track (rhythm track in Ketron proprietary format)
o VOICETRON: voice harmonization track.
• GM Voice Select: The button displays the name of the assigned GM voice, its bench
and the Program Change. Press it to open the GM VOICE SELECT page and change
the associated sound.
• EFX2 INSERT: Lower down you can see any INSERT effect associated with the track.
Press this button to open a list of all effects available to the system and select a
different one. Don't forget to press ON/OFF to activate it.
• ADJ VEIL: This value controls the sensitivity of the dynamics (positive values make the
track stronger, negative values make the track softer). Values range from -127 to
+127.
• VOL: Set the volume level from 0 to 127.
• SHIFT: This parameter is available only on tracks of VOICE category and controls the
transposition of the tone. Values range from -24 to +24.
• REV: Set the reverb send level. Values range from 0 to 127. See the DSP Effect Control
paragraph to change the reverb type.
• CHO: Set the delivery level of the Chorus. Values range from 0 to 127. See the DSP
Effect Control paragraph to change the Chorus type.
• PAN: Controls the position on the stereo panorama of the track. Values range from -
64 (all left) to 64 (all right) with the value "--" as the centre position (>|<).
At the bottom of the screen, there are the MUTE, SOLO and ADR filter buttons that open the
GM VOICE EDIT page where you can adjust the attack, decay and release of the amplitude
To Next Page
Loading...
