Changing the Default Settings 4
Keysight U1253B User’s and Service Guide 113
4
BAUD 9600 Baud rate for remote communication with a PC (remote control). Available
options: 2400, 4800, 9600, and 19200.
DATA BIT 8 Data bit length for remote communication with a PC. Available options: 8 bits or
7 bits (stop bit is always 1 bit).
PARITY NONE Parity bit for remote communication with a PC. Available options: NONE, ODD,
or EVEN.
ECHO OFF Return of characters to PC in remote communication. Available options: ON or
OFF.
PRINT OFF Prints measured data to a PC in remote communication. Available options: ON
or OFF.
5
REVISION NN.NN Revision number. Editing is disabled.
S/N NNNNNNNN The last 8 digits of the serial number will be indicated. Editing is disabled.
V-ALERT OFF Audible alert tone for voltage measurement.
– To enable this function, select an overvoltage value within the range of
1 V to 1010 V.
– To disable this function, set all digits to zero (“OFF” will be indicated).
M-INITIAL FACTORY Initial measurement functions. Available options: FACTORY or USER.
SMOOTH NORMAL Refresh rate for primary display readings. Available options: FAST, NORMAL, or
SLOW.
6
DEFAULT NO
Select YES, then press for longer than 1 second to reset the multimeter
to its default factory settings.
BATTERY 7.2 V Battery type used for the multimeter. Available options: 7.2 V or 8.4 V.
DC FILTER OFF Filter for DC voltage or DC current measurement. Available options: OFF or ON.
Table 4-1 Default factory settings and available setting options for each feature (continued)
Menu Feature
Default factory
setting
Available setting options
To Next Page
Loading...
