193
4
4
Features of your vehicle Windscreen defrosting and defogging
4. The fan speed will be increased.
To cancel or reset the Auto Defog
-
ging System
Press the front windscreen
defroster button for 3 seconds
when the ignition switch or ENGINE
START/STOP button is in the ON
position.
When the Auto Defogging System is
cancelled, defrost button indicator
will blink 3 times.
When the Auto Defogging System is
reset, defrost button indicator will
blink 6 times without a signal.
䳜 When the air conditioning is
turned on by Auto defogging sys
-
tem, if you try to turn off the air
conditioning, the indicator will
blink 3 times and the air condi
-
tioning will not be turned off.
䳜 To maintain the effectiveness and
efficiency of the Auto Defogging
System, do not select Recircula
-
tion mode whilst the system is
operating.
䳜 When the Auto Defogging System
is operating, the fan speed
adjustment knob, the tempera
-
ture adjustment knob, and the air
intake control button are all dis
-
abled.
Do not remove the sensor cover
located on the upper end of the
driver side windscreen glass.
Damage to system parts could
occur and may not be covered by
your vehicle warranty.
Defroster
The vehicle is equipped with a
defroster for removing frost or fog
from the rear window.
Conductors
To prevent damage to the conduc
-
tors bonded to the inside surface of
the rear window, never use sharp
instruments or window cleaners
containing abrasives to clean the
window.
If you want to defrost and defog the
front windscreen, refer to "Wind
-
screen defrosting and defogging" on
page 4-190.
To Next Page
