153
4
4
Features of your vehicle Lighting
䳜 Headlamps have been damaged or
not repaired properly.
䳜 Headlamps are not aimed prop
-
erly.
䳜 Driving on a narrow curved road,
rough road, uphill or downhill.
䳜 Vehicle in front is partially visible
on a crossroad or curved road.
䳜 There is a traffic light, reflecting
sign, flashing sign or mirror
ahead.
䳜 There is a temporary reflector or
flash ahead (construction area).
䳜 The road conditions are bad such
as being wet, iced or covered with
snow.
䳜 A vehicle suddenly appears from a
curve.
䳜 The vehicle is tilted from a flat
tyre or is being towed.
䳜 Light from a vehicle is not
detected because of exhaust
fume, smoke, fog, snow, etc.
For more details on the limitations
of the front view camera, refer to
"Forward Collision-Avoidance Assist
(FCA) (Sensor fusion) (if equipped)"
on page 6-74
䳜 At times, High Beam Assist may
not work properly. The function is
for your convenience only. It is the
responsibility of the driver for
safe driving practices and always
check the road conditions for your
safety.
䳜 When High Beam Assist does not
operate normally, change the
headlamp position manually
between high beam and low
beam.
Headlight levelling adjustment
switch (if equipped)
To adjust the headlamp beam level
according to the number of the pas
-
sengers and loading weight in the
luggage area, turn the beam level
-
ling switch.
The higher the number of the
switch position, the lower the head
-
light beam level. Always keep the
headlight beam at the proper level
-
To Next Page
Loading...
