What to do in an emergency
327
If you have a flat tyre (with tyre mobility kit)
4. Unscrew the valve cap from the
valve of the defective tyre and
screw the filling hose of the com
-
pressor onto the tyre valve.
Securely install the sealant filling
hose to the valve. If not, sealant
may flow backward, possibly clog
-
ging the filling hose.
5. Ensure that the compressor is
switched off, position 0.
6. Connect between compressor and
the vehicle power outlet using the
cable and connectors.
7. Make the ignition switch or
ENGINE START/STOP button on
ON position.
8. Switch on the compressor and let
it run for approximately 5 ~ 7
minutes to fill the sealant up to
proper pressure. (refer to "Tyres
and wheels" on page 9-6). The
inflation pressure of the tyre
after filling is unimportant and
will be checked/corrected later. Be
careful not to overinflate the tyre
and stay away from the tyre
when filling it. When the tyre and
wheel are damaged, do not use
Tyre Mobility Kit for your safety.
If the tyre pressure is below 26 psi
(180 kPa), do not drive the vehicle.
The tyre may cause accident.
9. Switch off the compressor.
10.Detach the sealant feeling hose
from the valve. After using, leave
the sealant bottle and the com
-
pressor attached together.
To Next Page
