EasyManua.ls Logo

Kia XCeed 2020 - Distributing The Sealant; Checking The Tire Inflation Pressure

Kia XCeed 2020
725 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
What to do in an emergency
IF YOU HAVE A FLAT TIRE (WITH TIRE MOBILITY KIT)
7
35
Onlyusethefrontpassengerside
poweroutlet.
10.Withtheignitionswitched
onorENGINESTART/STOP
buttonpositionon:Switchon
thecompressorandletitrun
forapproximately3minutes
tofillthesealant.Theinflation
pressureofthetireafterfillingis
unimportant.
11.Switchoffthecompressor.
12.Detachthehosefromthe
sealantbottleconnectorand
fromthetirevalve.
Distributing the sealant
• Immediatelydriveapproximately
7~10km(4~6milesor,about
10min)toevenlydistributethe
sealantinthetire.
ReturntheTireMobilityKittoits
storagelocationinthevehicle.
WARNING
Carbonmonoxidepoisoningand
suffocationispossibleiftheengine
isleftrunninginapoorlyventilated
orunventilatedlocation(suchas
insideabuilding).
CAUTION
Donotexceedaspeedof60km/h
(35mph).Ifpossible,donotfall
belowaspeedof20km/h(12mph).
Whiledriving,ifyouexperienceany
unusualvibration,ridedisturbanceor
noise,reduceyourspeedanddrive
withcautionuntilyoucansafelypull
offofthesideoftheroad.Callfor
roadsideserviceortowing.
WhenyouusetheTireMobility
Kit,thewheelmaybestained
bysealant.Therefore,remove
thewheelstainedbysealant
andhavethevehicleinspected
ataprofessionalworkshop.Kia
recommendstovisitanauthorized
Kiadealer/servicepartner.
Checking the tire inflation pressure
1.Afterdrivingapproximately
7~10km(4~6milesorabout
10minutes),stopatasuitable
location.
2.Connectthefillinghose(3)ofthe
compressor(clipmountedside)
directlyandthenconnectthe
fillinghose(3)(oppositeside)to
thetirevalve.
3.Connectbetweencompressorand
thevehiclebatteryusingthecable
andconnectors.
4.Adjustthetireinflationpressure
to200kPa(29psi).Withthe
ignitionswitchedon,proceedas
follows.
-Toincreasetheinflation
pressure:Switchonthe
compressor,positionI.Tocheck
thecurrentinflationpressure

Table of Contents

Related product manuals