KidKraft Cedar Summit DEVONSHIRE ELITE - Step 2: Front Wall Assembly

19
1 x Cross Support - Middle 1-1/4 x 3 x 41-7/16”
1 x TB Support 1-1/4 x 2-1/2 x 42-15/16”
1 x Cross Frame 1-1/4 x 3 x 62-1/4”
1 x Front Post Right 1-1/4 x 3 x 89”
1 x Front Post Left 1-1/4 x 3 x 92”
1 x Right Upright Front 1-1/4 x 3 x 22-1/2“
1 x Left Upright Front 1-1/4 x 3 x 16-1/2”
1 x Center Upright 1-1/4 x 3 x 58-1/2”
9365
9375
9362
9372
9361
9368
9369
9364
Fig. 2.1
Wood Parts
Step 2: Front Wall Assembly
Part 1
Hardware
6 x 5/16 x 1” Wafer Bolt
(FW2, TN2)
WB1
9368
Note: All bolts are installed loosely from the underside of panel assembly.
A: On the ground lay at (9368) Right Upright Front and to the right of it lay at (9369) Left Upright Front, making
sure that the notches on both boards are facing up and that they are oriented as shown in g. 2.1. Place (9365) TB
Support across the top of the Uprights so that it ts into the notches and the edges are ush as shown in g. 2.1.
Attach (9365) TB Support to each Upright using 1 (WB1) 5/16 x 1” Wafer Bolt (with at washer and t-nut) per side.
B: Place (9364) Center Upright under the pre-drilled center hole in (9365) TB Support and attach using 1 (WB1)
5/16 x 1” Wafer Bolt (with at washer and t-nut). (g. 2.1)
C: Lay at (9375) Front Post Right and to the right side of it lay at (9361) Front Post Left, making sure that the
notches on both boards are facing up and that they are oriented as shown in g. 2.2. Place (9372) Cross Frame
across the bottom of the Posts as shown in g. 2.2 and attach each side using 1 (WB1) 5/16 x 1” Wafer Bolt (with
at washer and t-nut).
D: Place 1 (9362) Cross Support Middle so that it ts into the center notches of each Post taking note of the hole
orientation. Attach (9362) Cross Support Middle to (9375) Front Post Right using 1 (WB1) 5/16 x 1” Wafer Bolt
(with at washer and t-nut). (g. 2.2)
9369
x 3
9372
9375
9361
9362
Fig. 2.2
WB1
9365
9364
x 3
WB1
TN2
TN2
FW2
FW2