Model 3605M0312-01
07/20 7-1
Troubleshooting
CLOSING WHEEL
PROBLEM POSSIBLE CAUSE SOLUTION
Closing wheel(s) leave severe imprint in soil.
Too much closing wheel down pressure. Adjust closing wheel pressure.
Closing wheel(s) not firming soil around seed. Not enough closing wheel down pressure. Adjust closing wheel pressure. Severe no till conditions may
require use of cast iron closing wheels.
“V” closing wheel running on top of seed
furrow.
Improper centering. Align. See “V Closing Wheel Adjustment”.
Single closing wheel not directly over seed. Improper centering. Align. See “Covering Discs/Single Press Wheel Adjustment”.
BULK FILL
PROBLEM POSSIBLE CAUSE SOLUTION
Seed does not travel through delivery tubes. System pressure set too low. Increase system pressure.
Seed stops flowing to row unit during planting. Seed surging. Shut down bulk fill system and restart system from idle; seed
should start flowing.
Debris in system. Insert shutoff door, open cleanout door. remove plug.
Seed does not move from entrainer at startup
after exposure to water.
Seed swelled in entrainer. Insert shutoff door, open cleanout door. remove swelled seed.
To Next Page
Loading...
