Model 3605M0312-01
07/20 2-35
Machine Operation
Recommended pressures:
For specific pressures for each seed, See "Vacuum Settings" on page 3-16.
Bulk fill tank lid latch
BULK FILL SYSTEM
1. Before filling hoppers refer to “Row Unit Operation” for
additives information. Fill hoppers with seed, latch lids,
and secure with pin.
2. Start bulk fill system with tractor engine at idle.
3. Increase engine speed to full and set initial system
pressure using flow control valve.
4. Allow system to warm up and adjust pressure if necessary.
Counterclockwise
to open
Seed flying out of disconnected delivery
tube at high velocity can cause injury.
Do not disconnect delivery tubes when
system is operating.
CAUTION
Foreign materials can plug system. Make
sure seed is clean and free of debris
when filling bulk fill hoppers.
NOTICE
Do not turn on system with tractor
engine at full speed or system damage
may occur.
NOTICE
Do not operate bulk fill system above
maximum system operating pressure of
20 inches of water (51 cm of water) or
seed bridging may occur.
NOTICE
To Next Page
Loading...
