Chapter 4 Menu operations MDC-2200/2500 Series
0093125002-05 4-58
4.18 INITIAL menu
Following designation items are provided in Initial menu.
(1) Readout of setup items
IMPORTANT: Setting values must be saved beforehand.
Readout setting value previously saved in item (2) Setup save operation.
It is used to recover setting values in case that radar operation becomes abnormal and unrecoverable
etc.
Saved setting value is read and set by proceeding [SETUP LOAD] => [EXEC] => [ENT] key operation.
Note: Saved setting values of previous version software can not be readout after change of device
software version.
(2) Setup save
This operation enables to save setting values when initial setup operation is complete or setting
alternation or data input (mark, navline, alarm2 data etc.) are performed.
When operation of main unit becomes abnormal and the setup values can not be recovered, setup
values can be recovered by using “Readout of setup items” shown in above item (1).
Current setup value is saved by [SETUP SAVE] => [EXEC] => Press [ENT] key.
SETUP LOAD
SETUP SAVE
EXT LOAD
EXT SAVE
SYS PRG LOAD
ATA PRG LOAD
AIS PRG LOAD
MARK LOAD
MARK SAVE
PAST LOAD
PAST SAVE
PRESET LOAD
This menu is displayed only in detailed menu during pre-heating or standby screen.
This menu cannot be operated during transmission.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
To Next Page
