Chapter 3 Basic operation MDC-2200/2500 Series
0093125002-04 3-14
6 For [EBL2] and [VRM2], the same procedure as that for [EBL1] and [VRM1] is taken to set up.
3.11 Change echo color (DAY/NIGHT)
This function is used to change echo colors on the screen depending on day and night navigation to
make viewing easier.
The image and background color can be set independently for daytime or for nighttime, for which the
echo color shall be registered beforehand.
(For MDC-2200)
1 Press [MENU] key to display “Menu”.
Select [ECHO] => [DAY/NIGHT] and select Day echo or Night echo color then press [ENT] key.
(For MDC-2500)
1 Press [DAY/NIGHT] key to switch over Echo color to Day echo and Night echo alternatively.
The above can be operated by using Menu.
3.12 Remove the heading line
This function is used when a target is overlapped with a heading line and hard to be observed.
1 Press [OFF] key to temporarily hide the heading line.
A target toward on the heading line becomes easier to observe while the key is kept being
pressed. (It is not possible to remove it continuously.)
There is a function to make heading line blinking without key operation. (Detailed menu=>
[MARKER] => [HL BLINK] => ON)
To Next Page
Loading...
