Kontron CP3003-SA - General Purpose Output Register (GPOUT)

CP3003-SA Configuration
ID 1052-6929, Rev. 3.0 Page 4 - 17
D R A F T — F O R I N T E R N A L U S E O N L Y
4.2.16 General Purpose Output Register (GPOUT)
The General Purpose Output Register holds the general purpose output signals of the rear I/O
CompactPCI connector J2. This register can be used only if the CP3003-SA is ordered as a rear
I/O version and the rear I/O GPIO operation is configured through the dedicated rear I/O module
configuration signal on the CompactPCI J2 connector.
Table 4-18: General Purpose Output Register (GPOUT)
REGISTER NAME GENERAL PURPOSE OUTPUT REGISTER (GPOUT)
ADDRESS 0x292
BIT NAME DESCRIPTION
RESET
VALUE
ACCESS
7 - 3 Res. Reserved 00000 R
2 GPO2 General purpose output 2 signal (3.3V LVTTL):
0 = Output low
1 = Output high
0R/W
1 GPO1 General purpose output 1 signal (3.3V LVTTL):
0 = Output low
1 = Output high
0R/W
0 GPO0 General purpose output 0 signal (3.3V LVTTL):
0 = Output low
1 = Output high
0R/W