Kontron CP3003-SA - Rear I;O Compactpci Connector Rj2

CP-RIO3-04 Rear I/O CP3003-SA
Page C - 12 ID 1052-6929, Rev. 3.0
D R A F T — F O R I N T E R N A L U S E O N L Y
Table C-9: Rear I/O CompactPCI Connector rJ2 Pinout
PIN ROW Z ROW A ROW B ROW C ROW D ROW E ROW F
22 NC NC NC NC NC NC GND
21 NC NC GND USBA+ / bi USBB+ / bi USBA_PWR_5V
/ in
GND
20 NC NC GND USBA- / bi USBB- / bi USBB_PWR_5V
/ in
GND
19 NC GND GND PWR_BTN# / out PWR_SLPS3#
/ in
RIO_3.3V / in GND
18 NC COMA_RXD /
out
COMA_DCD# /
out
COMA_DTR# / in COMB_CTS#
/ out
COMA_CTS# /
out
GND
17 NC COMA_TXD / in COMB_RXD /
out
NC NC NC GND
16 NC COMA_DSR# /
out
COMA_RTS# /
in
NC RSV COMA_RI# / out GND
15 NC PWR_5VSTDBY
/ out
RSV NC NC NC GND
14 NC lPA_DA+ / bi lPA_DA- / bi COMB_RTS# / in lPA_DC+ / bi lPA_DC- / bi GND
13 NC lPA_DB+ / bi lPA_DB- / bi COMB_RI# / out lPA_DD+ / bi lPA_DD- / bi GND
12 NC lPB_DA+ / bi lPB_DA- / bi RIO_1V9 / in lPB_DC+ / bi lPB_DC- / bi GND
11 NC lPB_DB+ / bi lPB_DB- / bi COMB_DCD# /
out
lPB_DD+ / bi lPB_DD- / bi GND
10 NC GND COMB_TXD /
in
VGA_RED / in COMB_DTR#
/ in
GND GND
9 NC SATAATX+ / in GND VGA_HSYNC / in GND SATABTX+ / in GND
8 NC SATAATX- / in GND VGA_BLUE / in GND SATABTX- / in GND
7 NC GND COMB_DSR# /
out
VGA_DDC_DATA
/ bi
RSV GND GND
6 NC SATAARX+ / out GND VGA_GREEN / in GND SATABRX+ / out GND
5 NC SATAARX- / out GND VGA_VSYNC / in GND SATABRX- / out GND
4 NC NC RIO_5V / in VGA_DDC_CLK /
in
GPIO_CFG0 /
out
GND GND
3 NC NC GND NC NC NC GND
2NCNC NC NC NC NC GND
1NCNC NC NC NC NC GND
Warning!
The RIO_XXX signals are power supply INPUTS to supply the rear I/O module
with power. These pins MUST NOT be connected to any other power source,
either within the backplane itself or within a rear I/O module.
Failure to comply with the above will result in damage to your board.