Program mode
40
PROG P3–2: Filter2
3–2–1: Filter2
This page controls Oscillator 2’s basic filter 2 settings. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–1–1: Filter1,” on page 30.
3–2–2: Keyboard Track
This page contains the settings for Oscillator 2’s keyboard
track. Among other things, you can:
• Set up complex keyboard tracking shapes, and control
how the tracking affects filter cutoff.
• Control the effect of the Filter Envelope on filter cutoff.
•Assign AMS modulation for filter cutoff.
Filter B is available when the Filter Routing is set to Serial
or Parallel. Otherwise, the parameters for Filter B will be
grayed out.
3–2–3: Modulation
This page controls Oscillator 2’s filter modulation. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–1–3: Modulation,” on page 34.
3–2–4: LFO Mod. (Modulation)
This page controls Oscillator 2’s LFO filter modulation. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–1–4: LFO Mod. (Modulation),” on
page 36.
3–2–5: EG
This page controls Oscillator 2’s Filter EG. It is available only
when the Oscillator Mode is set to Double; if not, the page
will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–1–5: EG,” on page 37.
To Next Page
Loading...
