Korg M50-88 - 7-3: Arpeggiator A, 7-4: Arpeggiator B

Combination mode
108
This type of setting is used in preloaded combinations
which sound the drums only when the arpeggiator is on.
Arpeggiator Run A, B [Off, On]
When the ARP ON/OFF switch is on, the arpeggiator(s)
checked here will run if they are assigned to a timbre by
Arpeggiator Assign.
▼7–1(2): Menu Command
• 0: Write Combination ☞p.120
• 1: Exclusive Solo ☞p.120
• 2: Copy from Program ☞p.120
• 3: Copy Arpeggiator ☞p.122
For more information, please see “Combination: Menu
Command” on page 120.
7–3: Arpeggiator A,
7–4: Arpeggiator B
7–3(4)a: Combination Name, Tempo
For more information, please see “2–1: EQ Trim T01–08, 2–2:
EQ Trim T09–16” on page 93.
For more information, please see “ (Tempo)” on page 81.
7–3(4)b: Arpeggiator-A(B) Setup
Pattern* [P0...P4, U0000(INT)...U0899(INT),
U0900(USER)...U1027(USER)]
Octave* [1, 2, 3, 4]
Resolution* [  ,  ,   ,  ,   ,  ]
Gate [000...100%, Step]
Velocity [001...127, Key, Step]
Swing [–100...+100%]
Sort* [Off, On]
Latch* [Off, On]
Key Sync.* [Off, On]
Keyboard* [Off, On]
These parameters are the arpeggiator settings for the
combination.
For more information, please see “PROG P7: ARP/DT
(Arpeggiator/Drum Track)” on page 59.
* These parameters can also be set from “0–5(6)c:
Arpeggiator A (B)”.
▼7–3(4): Menu Command
• 0: Write Combination ☞p.120
• 1: Exclusive Solo ☞p.120
• 2: Copy from Program ☞p.120
• 3: Copy Arpeggiator ☞p.122
For more information, please see “Combination: Menu
Command” on page 120.
Pattern - B
Pattern - A
Timbre 2 MIDI Ch=Gch Status=Off
Timbre 3 MIDI Ch=2ch Status=INT
Arpeggiator
A
Arpeggiator
B
Arpeggiator
Assign
A
A
Pattern - A
Pattern - B
Trigger
= Gch, Ch2
Trigger
= Gch, Ch3
Timbre 4 MIDI Ch=Gch Status=Off
B
Timbre 5 MIDI Ch=3ch Status=INT
B
Off
Timbre 1 MIDI Ch=Gch Status=INT
Sounded by normal
keyboard playing
Does not sound
Does not sound
7–3a
7–3
Menu
7–3b