Shortcuts Recording the Arpeggiator or RPPR function on an external MIDI sequencer/computer
405
Shortcuts
ENTER switch + numeric keys 0–9
•Accesses the menu commands in each page (up to ten
items)
ENTER switch + REC/WRITE switch
•Accesses the Auto Song Setup function. In Program or
Combination mode you can press this combination of
keys to automatically assign the settings of the program
or combination to a song in Sequencer mode, and then
enter record-ready mode.
ENTER switch + keyboard
• Inputs note number values or velocity values
• Selects “KEY” in Global P5: Drum Kit, Seq P10: Pattern/
RPPR, RPPR Setup page
• Selects base key and index in Sampling mode
Note: While a dialog box is displayed, the ENTER switch
will perform the same function as the OK button. This
means that you can’t use this method to enter a note number
or velocity value in a dialog box that contains an OK button.
ENTER switch + LOCATE switch
• In Sequencer mode, sets the current location as the
“Location” (equivalent to the Set Location menu
command)
ENTER switch
While a dialog box is displayed, this switch performs the
same operation as the OK button.
PAGE SELECT switch + numeric key 0–9
By holding down the PAGE SELECT switch and pressing a
numeric key 0–9 you can jump to the corresponding page.
Note: In pages that contain multiple sub-pages, the first
page (e.g., P3–1 or P8–1) will be selected.
EXIT switch
This button makes it easy to return to the main page of the
current mode:
1. Press it once to go to the previously-selected tab on the
main P0 page.
2. Press the EXIT switch. You will move to the previously-
selected parameter of the P0 top page (Prog: Main,
Combi/Seq: Program T01–08).
3. Press the EXIT switch. You will move to the following
parameter of the P0 top page.
(Prog: “Program Select”
Combi: “Combination Select”
Seq: “Song Select”)
In any page of Program or Combination mode, pressing
EXIT a maximum of two times will immediately allow you
to use the numeric keys or q/uswitches to select programs
or combinations. In Sequencer mode, pressing EXIT a
maximum of three times will allow you to select a song.
EXIT switch (in dialog boxes)
When a dialog box is displayed, this has the same function
as the Cancel, Done, or Exit button.
From a powered-off condition, turn on the power
while holding down the RESET CONTROL switch +
REALTIME CONTROL switch
• Initializes the M50, and writes data into internal
memory. (A message of “Now writing into internal
memory” will appear in the display while the data is
being loaded.)
After initialization, you will need to load the preload
data. Execute the Global mode menu command Load
Preload/Demo Data to load the data. (See page 251)
To Next Page
Loading...
