Combination mode
98
3–7: Other T01–08,
3–8: Other T09–16
Here, you can make settings for the scale of timbres 1–8 and
9–16.
3–7(8)a: Combination Name, Tempo
3–7(8)b: Timbre Info
For more information, please see “2–1: EQ Trim T01–08, 2–2:
EQ Trim T09–16” on page 93.
3–7(8)c: Scale
Timbre 01 (Timbre Number):
Use Program’s Scale [Off, On]
Timbre can use the scale that is specified by Scale (Prog 1–
2b).
On (checked): The scale specified by the program will be
used.
Off (unchecked): The scale specified by Type (Combi’s
Scale) (Combi 3–7(8)c) will be used.
Timbre 02...08, 09...16 (Timbre Number):
Here, you can make settings for the scale of each timbre 2–8
and 9–16. The settings are the same as for timbre 1. For more
information, please see “Timbre 01 (Timbre Number):,”
above.
Scale:
This specifies the scale that the combination will use. For
more information, please see “1–2b: Scale” on page 17.
Type (Combi’s Scale)
[Equal Temperament...User Octave Scale15]
Selects the scale.
Key [C…B]
Selects the tonic key of the selected scale.
Random [0…7]
As this value is increased, an increasingly random deviation
will be added to the pitch at each note-on.
If Status (Combi 3–1(2)c) is INT, this setting will affect
the pitch produced by the M50. If Status is EXT, this
setting will affect the note number of the note messages
transmitted via MIDI.
▼3–7(8): Menu Command
• 0: Write Combination ☞p.120
• 1: Exclusive Solo ☞p.73
•2: Copy from Program ☞p.120
For more information, please see “Combination: Menu
Command” on page 120.
3–7a
3–7b
3–7c
3–7
Menu
To Next Page
Loading...
