Program mode
14
0–8d: External
MIDI Channel [01...16, G]
This read-only parameter shows the MIDI Channel
assignment for the knob. Each can send on a different
channel, if desired.
G means that the knob will transmit on the Global MIDI
Channel, as set in Global mode.
CC# Assign [Off, 000...119]
This read-only parameter shows the MIDI CC sent by the
knob.
Value [000...127]
This is the current value of the knob’s MIDI CC.
ARP
Arpeggio control lets you use the four knobs to control the
arpeggiator performance in realtime.
0–8b: Control Assign
Control Assign [Realtime Control, External, ARP]
This selects the items that will be affected by the control
surface.
0–8e: Arpeggiator
The functions of knobs 1–4 are fixed. The knobs will control
the duration of the arpeggiated notes, their velocity, the
pitch range, and the length of the arpeggio pattern.
Knob 1: Gate [–64...+00...+64]
Adjusts the duration (gate time) of the arpeggiated notes
(See “Gate” on page 60).
Knob 2: Velocity [–64...+00...+64]
Adjusts the velocity of the arpeggiated notes (See “Velocity”
on page 60).
Knob 3: Length [–64...+00...+64]
Adjusts the length of the arpeggio pattern.
Knob 4: Octave [–64...+00...+64]
Adjusts the pitch range over which the arpeggiator will play,
in one-octave steps (See “Octave*” on page 59).
If Arpeggio Tone Mode is set to Fixed Note, operating
knob 4 will not affect the pitch range.
▼0–8: Menu Command
• 0: Write Program ☞p.73
• 1: Exclusive Solo ☞p.73
For more information, please see “Program: Menu
Command” on page 73.
0–8a
0–8b
0–8e
0–8
Menu
To Next Page
Loading...
