Global mode
218
▼0–1: Menu Command
• 0: Write Global Setting ☞p.251
• 1: Load Preload/Demo Data ☞p.251
• 2: Change all bank references ☞p.251
•3: Touch Panel Calibration ☞p.252
•4: Half Damper Calibration ☞p.252
•5: Update System Software ☞p.252
For more information, please see “Global: Menu Command”
on page 251.
0–2: System Preference
Here, you can make overall settings for the entire system
such as bank map, and memory protect.
0–2a: System Preference
Bank Map [KORG, GM(2)]
This specifies the mapping of programs and combinations
relative to Bank Select control change messages (CC#0
upper byte and CC#32 lower byte).
The bank select messages shown in the table below will be
received (R) and transmitted (T) for Program banks A–E,
GM, g(1)…g(9), g(d) and Combination banks A–D.
Power On Mode [Reset, Memorize]
Specifies the condition at power-on.
Reset: The M50 will be in Program mode P0: Play, and
Program A000 will be selected.
Memorize: The location (mode and page) which you most
recently accessed when you last powered-off the M50 will be
recalled. If you were in Program or Combination mode, the
program or combination bank/number at power-off will be
recalled.
Before turning off the power, be sure to write your data
or save it in Media mode. This function does not
memorize the contents of any parameters that were
edited.
Beep Enable [Off, On]
On (checked): A beep will be heard when you press an
object in the display.
Off (unchecked): No beep will be heard.
Bank Bank Map: KORG Map: GM(2)
A 00. 00 R/T 63. 00 R/T
B 00. 01 R/T 63. 01 R/T
C 00. 02 R/T 63. 02 R/T
D 00. 03 R/T 63. 03 R/T
E 00. 04 R/T 63. 04 R/T
GM, 121. 00 R/T, 56. 00 R 121. 00 R/T, 56. 00 R, 00. 00 R
g(1)...g(9) 121. 01...09 R/T 121. 01...09 R/T
g(d) 120. 00 R/T, 62. 00 R 120. 00 R/T, 62. 00 R
0–2a
0–2b
0–2
Menu
To Next Page
Loading...
