Sequencer mode
148
1–2: Chord Trigger Setup
For each song, you can assign the note numbers and
velocities that will be produced by chord trigger switches 1–
4. You can assign up to eight note numbers and their
velocity for each chord trigger switch.
1–2a: Chord Trigger Switch
SW 1:
MIDI Channel [Ch01...Ch16, Tch]
This sets the chord trigger switch’s MIDI output channel.
You can set this to either a specific channel (1–16), or to
follow the channel of the selected Track.
Ch01…Ch16: The switch will transmit on the selected MIDI
channel. As shown in the diagram below, you can:
Use this in conjunction with the Track MIDI Channel (Seq
3–1(2)c) setting, to route a switch to a specific Track.
Tch: With this setting, the switches will follow the MIDI
Channel (Seq 3–1(2)c) of the currently selected Track.
Notes 1–8 [Off, C–1…G9 / 001…127]
These parameters let you edit the 8 notes assigned to each
switch, along with a separate velocity for each note. To play
fewer than 8 notes, just set the unwanted notes to Off.
Off: Select this to disable the note.
C–1…G9: This sets the note number.
001…127: This sets the note’s velocity value. For more
information on switches and velocity, please see “1–8a:
Chord Trigger Switches” on page 20.
SW 2...4
These are the same as for SW 1, as described above.
▼1–2: Menu Command
• 0: Memory Status ☞p.191
• 1: Exclusive Solo ☞p.73
•2: Rename Song ☞p.191
•3: Delete Song ☞p.191
•4: Copy From Song ☞p.191
•5: Load Template Song ☞p.191
•6: Save Template Song (Save as User Template
Song) ☞p.192
•7: FF/REW Speed ☞p.192
•8: Set Location (Set Location for Locate Key) ☞p.192
•9: GM Initialize ☞p.193
• 10: Copy From Combi (Copy from
Combination) ☞p.194
• 11: Copy from Program ☞p.195
• 12: Copy Chord Trigger Setup ☞p.195
For more information, please see “Sequencer: Menu
Command” on page 191.
1–2a
1–2
Menu
T01: Piano
T02: Strings
1ch
1ch
1ch
2ch
T03: Bell
2ch
T01: Piano
T02: Strings
1ch
2ch
1ch
3ch
T03: Bell
3ch
Arpeggiator A
SW1
SW2
SW1
SW2
1ch
1ch
1
2
1
2
Arpeggiator B
To Next Page
Loading...
