Sequencer mode
180
SEQ P9: MFX/TFX (Master/Total Effect)
Here, you can adjust the settings for the master effects and
the total effect. For instance, you can:
• Route a sound to the master effects and the total effect
•Make detailed settings for the master effects and the
total effect
For more information, please see “Effect Guide” on
page 271.
9–1: Routing
•Here, you can specify the type of master effects and total
effect, and turn them On/Off.
• The master effects are sent to the L/R bus. The total
effect is inserted into the L/R bus.
These parameters are the same as in Program mode. For
more information, please see “9–1: Routing” on page 70.
9–1a: Track Select
For more information, please see “2–1: Trim T01–08, 2–2:
Trim T09–16” on page 149.
9–1b: MFX1, 2
MFX1:
MFX1 [000...170]
MFX1 On/Off [Off, On]
Return 1 [000...127]
MFX2:
MFX2 [000...153]
MFX2 On/Off [Off, On]
Return 2 [000...127]
Chain:
Chain On/Off [Off, On]
Chain Direction [MFX1→MFX2, MFX2→MFX1]
Chain Level [000...127]
For more information, please see “9–2: MFX1” on page 71.
9–1c: TFX
TFX:
TFX [000...153]
TFX On/Off [Off, On]
For more information, please see “9–4: TFX” on page 72.
9–1d: Master Volume
Master Volume [000...127]
For more information, please see “9–1c: Master Volume” on
page 71.
▼9–1: Menu Command
• 0: Memory Status ☞p.191
• 1: Exclusive Solo ☞p.73
•2: Copy Insert Effect ☞p.76
•3: Swap Insert Effect ☞p.76
•4: FF/REW Speed ☞p.192
•5: Set Location (Set Location for Locate Key) ☞p.192
•6: Put Effect Setting to Track ☞p.204
For more information, please see “Sequencer: Menu
Command” on page 191.
9–1b
9–1a
9–1c
9–1b
9–1d
9–1
Menu
To Next Page
Loading...
