Korg M50-88 - Effect I;O

Overview Effect I/O
275
Effect I/O
To achieve the best tonal quality, signals sent to the effects
should be at the maximum level below clipping. Also, use
the Wet/Dry parameter for the Insert Effects, Total Effect and
the “Wet/Dry” or “Return 1, 2” parameter for the Master
Effects to adjust the effect output level.
If the input level is too low, the SN ratio may decrease.
On the other hand, if the input level is too high,
clipping may occur.
The following table shows the parameters related to the
level settings:
Program mode
Combination mode/Sequencer mode
*1
Some effects may not have these parameters.
Input
OSC 1/2 Volume (P0)
OSC1/2 MS1, 2, 3, 4 Level (P2)
Filter1/2 Trim (P3)
Filter1/2 Output (P3)
Driver1/2 Drive (P4)
Amp1/2 Amp Level (P4)
EQ Input Trim (P4)
Send1/2 (P8)
Effect Trim parameter
*1
(P8, P9)
Output
Effect Wet/Dry parameter (P8, P9)
Return1, 2 (P9)
Master Volume (P9)
Input
Volume (P0)
Timbre EQ Input Trim (P2)
Send1/2 (P8)
Effect Trim parameter
*1
(P8, P9)
Output
Effect Wet/Dry parameter (P8, P9)
Return1, 2 (P9)
Master Volume (P9)