SEQ P7: ARP/DT (Arpeggiator/DrumTrack) 7–5: ARP Scan Zone
171
7–5: ARP Scan Zone
These settings specify the note and velocity ranges that will
operate arpeggiators A and B.
7–5a: Location, Meter, Tempo, Tempo
Mode, Song Select, Track Select,
Reso, RPPR
7–5b: Track Info
For more information, please see “0–1–1(2)a: Location,
Meter, Tempo, Tempo Mode, Song Select, Track Select, Reso,
RPPR” on page 129.
7–5c: Zone Map
This shows the Scan Zone for each arpeggiator, A and B.
For more information, please see “7–5b: Zone Map” on
page 109.
7–5d: Scan Zone
A:, B:
Top Key [C–1...G9]
Bottom Key [C–1...G9]
Specifies the range of notes (keys) that will operate
arpeggiator A (B). Top Key specifies the upper limit, and
Bottom Key specifies the lower limit.
Top Velocity [001...127]
Bottom Velocity [001...127]
Specifies the range of velocities that will operate arpeggiator
A (B). Top Velocity specifies the upper limit, and Bottom
Velocity specifies the lower limit.
Specifies the range of notes (keys) and velocities that will
operate arpeggiator A/B.
Note: The values of these parameters can also be entered by
holding down the ENTER switch and playing a note on the
keyboard.
▼7–5: Menu Command
• 0: Memory Status ☞p.191
• 1: Exclusive Solo ☞p.73
• 2: Rename Song ☞p.191
• 3: Delete Song ☞p.191
• 4: Copy From Song ☞p.191
• 5: Load Template Song ☞p.191
• 6: Save Template Song (Save as User Template
Song) ☞p.192
• 7: FF/REW Speed ☞p.192
• 8: FF/REW Speed ☞p.192
• 9: GM Initialize ☞p.193
• 10: Copy From Combi (Copy from
Combination) ☞p.194
• 11: Copy from Program ☞p.195
• 12: Copy Arpeggiator ☞p.75
For more information, please see “Sequencer: Menu
Command” on page 191.
7–5a
7–5b
7–5c
7–5d
7–5
Menu
To Next Page
