microKORG2 VOCAL PROCESSOR section - HARMONIZER
93
HARMONIZER
• Press the HARMONIZER button while holding down the ON/OFF button to turn the effect on/off
(the LED below the button lights up when the effect is on).
• Press the HARMONIZER button to show the related parameters (the button blinks). Use the EDIT
CONTROL 1–5 knobs and the FUNCTION 1, 2 buttons to set the value.
• Long-press the VOCODER, HARD TUNE or HARMONIZER button to access the VOCAL SETTING
page, where you can choose whether to correct the pitch according to the scale or the keyboard.
→ VOCAL SETTING
|
HARMONIZER A (HARMO A)
Adds harmonies (chord tones) to the vocal by shifting the original pitch of the vocal and outputting
the result.
You can output up to two harmonies in addition to the original sound.
1. Harmonies Level (HarmoLvl) [0...127] (NRPN 7, 1)
Sets the output level of the harmony sound.
2. Stereo Spread (Stereo) [-63...0...63] (NRPN 7, 2)
Sets the relative amount that the harmonies are spread out over the stereo field.
When Harmony Number is set to “1”, the harmonies move from left to right.
When Harmony Number is set to “2”, harmony 1 will move from left to right and harmony 2 will move
from right to left.
3. Formant [-63...0...63] (NRPN 7, 3)
Adjusts the formant of the harmony sound to change the vocal character.
This lets you change a thin, high voice into a thick, low voice (negative values), or a thick, low voice
into a thin, high voice (positive values).
4. Pitch Detune (Detune) [-63...0...63] (NRPN 7, 4)
Sets how much to detune (adjust the pitch slightly out of tune) the harmony sound.
5. Delay [0...150 mSec] (NRPN 7, 5)
Sets how much to delay the output of the harmonies in respect to the original sound.
To Next Page
Loading...
