microKORG2 TIMBRE EDIT section - OSC 1, OSC 2, OSC 3, NOISE
58
|
OSC 3
Here are the settings for oscillator 3 (OSC 3).
When applying oscillator modulation, oscillator 3 modulates oscillators 1 and 2, and oscillators 1 and 2
output the modulated result.
1. Wave [Saw, Square, Triangle, Sine, DWGS, OneShot] (CC#48)
2. Shape/Sample [SAW-Sine: 0...127/DWGS: 1...64, OneShot: 1...32] (CC#49)
These are the same as for oscillator 1 (OSC 1). → OSC 1
3. OSC Mod Type (ModType) [Disable, Ring, Sync, Ring&Sync, VPM]
Selects the type of oscillator modulation that’s produced in conjunction with oscillators 1 and 2.
Disable: No modulation is applied to the output sound.
Ring: This modulation generates the frequency sum and difference with the other two oscillator
waveforms. Adjust the Semitones and Fine Tune to create metallic, atonal sounds. This is useful for
sound effects.
Sync: This modulation forcibly synchronizes the phase of oscillators 1 and 2 to the phase of oscillator
3. This is effective for synth leads. Adjust the harmonics using the Semitones and Fine Tune values.
The pitch of the fundamental does not change.
To Next Page
Loading...
