Korg microKORG2 - Connecting to Other Devices; Connecting to a Power Source

microKORG2 Connecting and getting ready to play - Connecting to other devices
22
Connecting to other devices
| Connecting to a power source
Connecting the AC adapter
1 Connect the included AC adapter to the DC 9V jack.
2 After connecting, plug the AC adapter into an AC outlet.
Installing and replacing the batteries
The microKORG2 can also operate on batteries.
Note: Batteries are not included, and must be purchased separately.
1 Make sure that the power switch on the microKORG2 is turned off, and then open the battery
cover on the bottom of the case.
2 Insert six AA batteries (sold separately).
Before making any connections, ensure that all of your devices and audio equipment are
turned off. Operating this unit or your devices in a careless way might cause electric shock,
damage your speaker system or cause a malfunction.
Be sure to use only the included AC adapter. Using a different AC adapter may cause a mal-
function or other issues.