microKORG2 VOCAL PROCESSOR section - VOCODER
91
Tip:
The signal information that’s maintained in the hold state can be saved in the program by writing
the program. If you set this to “Hold” without an input signal present, no output is made even if an
audio signal is input after this.
|
FILTER BAND
On the FILTER BAND page, you can set the output level and panpot (stereo position) for the 16 filters
on the carrier side.
1. Band Select (Band Sel) [1...16]
Selects which bandpass filter the Level and Pan parameters will affect.
Note:
This setting is not saved in the program. When you turn on the microKORG2 or select a different
program, this value is reset to “1”.
2. Band X Level (Level) [0...127] (NRPN 5, 16...31)
Sets the output level for the filter that’s selected in Band Select.
3. Band X Pan (Pan) [L63...L1, Center, R1...R63] (NRPN 5, 32...47)
Sets the panpot for the filter that’s selected in “Band Select”.
To Next Page
Loading...
