microKORG2 Editing - Editing a synth program
43
Restoring a parameter to its original value
You can check the original values of the preset programs and saved programs by looking at the colors
in the center of the display knobs.
If a knob is filled in with its own color, this shows that the knob’s value has been changed. If the knob
is filled in with a slightly lighter color, its value is equal to the saved value.
Tip:
You can change how the knobs behave when the internal value doesn't match the position of the
knob with the “Knob Mode” parameter on the EDIT CONTROL page. → Details
|
Selecting a timbre
Each program can use two timbres.
Each timbre consists of the TIMBRE EDIT VOICE through PATCH 1–6 sections.
Using two timbres (dual)
1 Set Timbre Mode (Timb Mode) on the VOICE page to “Dual”.
2 Press the TIMBRE button to select the timbre to edit (the LED lights up).
3 Long-press the TIMBRE button to adjust the levels and panpots for the timbres 1 and 2.
To Next Page
Loading...
