microKORG2 Connecting and getting ready to play - Connecting to other devices
24
|
Connecting the included mic
Connect the included mic to the mic holder. While holding the base of the included mic, align the pro-
trusion on the mic with the guide of the mic holder, and push the mic into the holder. Do not use
excessive force.
Connect the included mic to the MIC IN CONDENSER jack.
|
Connecting from the audio outputs
Connect the OUTPUT L/MONO and R jacks of the microKORG2 to the input jacks of your mixer, pow-
ered monitor speakers or other audio equipment. We recommend that you connect the output of the
microKORG2 in stereo, to take advantage of its sonic capabilities. If you’re using a monaural connec-
tion, connect from the L/MONO jack.
When using headphones, connect them to the (headphones) jack.
|
Connecting to the audio inputs
If you want to use the vocoder, hard tune and harmonizer effects with a mic other than the one that’s
included, plug the mic into the MIC IN CONDENSER jack or the MIC DYNAMIC IN jack. → Input/output
jacks
To input the audio from an external source such as an audio player, plug the device into the AUX IN
jack. Adjust the volume on the external device.
|
Connecting a pedal switch
Connect your accessories such as a damper pedal or pedal switch (sold separately) to the DAMPER/
SWITCH jack. You can use a pedal or switch to control the damper effect or record with the loop
recorder.
Configuring the pedal functions
1 Press the EDIT GLOBAL button to access the CONTROL [2/5] page.
2 Turn the EDIT CONTROL 2 knob to set the pedal function.
If you want to use a mic other than the one that was included, connect it to the appropriate
jack.
To Next Page
Loading...
