microKORG2 TIMBRE EDIT section - VOICE, PITCH, ASSIGN
51
VOICE, PITCH, ASSIGN
|
VOICE
These settings are related to the programs overall as well as how the timbres sound.
This sets whether one timbre (Single) or two timbres (Dual) are used.
You can also set how the notes are triggered here, such as single notes/chords, unison and so forth.
1. Timbre Mode (Timb Mode) [Single, Dual]
Sets how many timbres the program will use.
Single: Only one timbre is used.
Dual: Two timbres are used. When you play the keyboard, both timbres play simultaneously. You can
edit the two timbres individually.
The maximum polyphony is eight voices (eight notes). In Dual mode, the maximum polyphony is four
voices (since timbres 1 and 2 are played together).
2. Poly / Mono [Poly, Mono Legato, Mono Retrigger]
Specifies how the timbres are triggered.
When this is set to monophonic mode, you can specify whether the EG and LFO are retriggered when
you play the next key while still holding down the previous key.
Poly: The program plays polyphonically, letting you play chords. The maximum polyphony is eight
voices.
Note:
This may vary depending on the settings.
Mono Legato: The sound plays monophonically (one note at a time). Only one sound for the timbre
can be played at a time. The EG and LFO will only reset for the first note played. Use this setting if you
want to play legato.
To Next Page
Loading...
