Keystage EDIT section - ARP A, B
77
4. Target Timbre (Target) [Both Timbre, Timbre 1, Timbre 2] (NRPN 0, 11)
Selects the timbres that are played by the arpeggiator.
Both Timbre: Both timbres are played by the arpeggiator.
Timbre 1: Only timbre 1 is played by the arpeggiator.
Timbre 2: Only timbre 2 is played by the arpeggiator.
Note:
This setting is available when Timbre Mode is “Dual”.
5. Latch [Off, On] (NRPN 0, 4)
Sets how the arpeggiator works when you take your hand off of the keyboard.
Off: The arpeggiator stops playing when you take your hand off the keyboard.
On: The arpeggiator keeps playing even if you take your hand off the keyboard.
Tip:
You can also toggle the latch by long-pressing the ARPEGGIATOR ON button.
|
ARP B
1. Type [Up, ..., Trigger] NRPN 0, 7
Selects the arpeggio type.
Up: Notes are played consecutively from low pitches to high.
Down: Notes are played consecutively from high pitches to low.
UpDown: Alternates between playing the notes up and then down. (The highest and lowest notes play
once.)
To Next Page
Loading...
