Korg microKORG2 - Backing up Your Data; Backing up the Programs and Global Data; Loading Programs and Global Data

microKORG2 Appendices - Backing up your data
123
Backing up your data
Use USB mass storage mode along with your computer to back up the programs and global data of
this instrument.
| Backing up the programs and global data
1 Connect the USB port on the microKORG2 to your computer with a USB cable.
2 Press the power button while holding down the FUNCTION 1 button to start up in USB mass
storage mode.
The “microkorg2” USB drive is shown on your computer, which contains a “Programs” folder and
a “Global” folder.
3 Copy the program data (.mk2prog) and the global data (.mk2glob) from the respective folders to
your computer to back up the data.
4 Press the FUNCTION 5 button to exit USB mass storage mode.
The microKORG2 restarts automatically.
Note: If you’re connected to a Mac, first eject the “microkorg2” USB drive on your Mac and then
perform the operations on the microKORG2.
| Loading programs and global data
1 Start the instrument in USB mass storage mode.
See steps 1 and 2 above for details.
2 Copy the backup program data (.mk2prog) and global data (.mk2glob) to their respective folders.
3 Press the FUNCTION 5 button to exit USB mass storage mode.
The microKORG2 restarts automatically. Now you can use the data you’ve copied.