Korg microKORG2 - Loop Setting B

microKORG2 LOOP RECORDER section - LOOP SETTING B
116
LOOP SETTING B
These are the loop recorder playback-related settings.
• Long-press the button to access the LOOP SETTING B page.
1. Stutter [Off, On Forward, On Reverse] (NRPN 8, 16)
The stutter function is used to repeatedly play back parts of short loops.
This parameter sets whether to enable the stutter function, playing back the loop at the length set in
“Stutter Length”.
Note: This is set to “Off” when you stop playback, start recording, or clear the loop data.
Off: Disables the stutter function.
On Forward: Enables the stutter function.
On Reverse: Plays back the stutter in reverse.
2. Stutter Length (St.Length) [1/1, 1/2, 1/4, 1/6, 1/8, 1/12, 1/16, 1/24, 1/32, 1/64, 1/128] (NRPN 8, 17)
Sets the stutter playback length.
3: Stutter Offset (St.Offset) [-63...0...63] (NRPN 8, 18)
You can shift the loop point of the stutter up to one measure.
Note: When Stutter is set to “Off”, this is reset to zero and you cannot change the value.
4. Count Level (Count Lvl) [0...127]
Sets the volume of the click that’s heard during the pre-count and when recording.
5. Loop Play Level (Play Lvl)[0...127] (NRPN 8, 19)
Sets the volume of the loop that’s played back by the loop recorder.