microKORG2 Functions - INITIALIZE (INIT), COPY, MANUAL, TROPHY
118
INITIALIZE (INIT), COPY, MANUAL, TROPHY
|
Initializing the programs and timbres (INIT)
1 Select a program to initialize.
2 Press the INIT (FUNCTION 1) button while holding down the FUNC (FUNCTION 5) button.
3 Turn the EDIT CONTROL knob 1 or press the INC, DEC buttons (FUNCTION 2, 1 button) to select
what to initialize.
4 Press the EXECUTE (FUNCTION 4) button to initialize. Press the CANCEL (FUNCTION 5) button to
cancel.
Initialize Target [PROGRAM, TIMBRE 1, TIMBRE 2]
Sets what part of the program to initialize.
Note:
Initializing does not overwrite the data stored in the microKORG2's memory— you must write the
program to memory if you want to save its initialized state.
|
Copying programs and timbres (COPY)
1 Select the copy destination program.
2 Press the COPY (FUNCTION 2) button while holding down the FUNC (FUNCTION 5) button.
3 Use the EDIT CONTROL 1–4 knob or the INC, DEC buttons (FUNCTION 2, 1 buttons) to select the
copy source program item or the copy destination timbre.
4 Press the EXECUTE (FUNCTION 4) button to execute the copy operation. Press the CANCEL
(FUNCTION 5) button to cancel.
Source Program [CLASSIC A1...USER H8]
Select a program from which you want to copy the settings to the current program.
Module [ALL, TIMBRE 1, TIMBRE 2, ASSIGN, ARP, PATCH, VOCAL PROCESSOR, EFFECT, EQ]
Select the program item to copy.
Timbre Parts [ALL, VOICE, PITCH, ...PATCH ALL]
When Module is set to “TIMBRE 1” or “TIMBRE 2”: Select the items to copy from the specified timbre.
Target Timbre [TIMBRE 1, 2]
When Module is set to “TIMBRE 1” or “TIMBRE 2”: Select the copy destination timbre.
Patch Parts [TIMBRE 1 PATCH 1...TIMBRE 2 PATCH 6]
When Module is set to “PATCH”: Select the patch to copy.
Target Patch [TIMBRE 1 PATCH 1...TIMBRE 2 PATCH 6]
When Module is set to “PATCH”: Select the copy destination patch.
Vocal Parts [VOCAL ALL ...HARMONIZER]
When Module is set to “VOCAL PROCESSOR”: Select the items to copy.
To Next Page
Loading...
