microKORG2 TIMBRE EDIT section - LFO 1, 2
67
LFO 1, 2
Each timbre has two LFOs (low-frequency oscillator). The cyclic change produced by an LFO can mod-
ulate various aspects of the sound such as the pitch, tone, or volume.
|
LFO 1
1. Wave [Triangle, Saw Down, Saw Up, Square, Sample & Hold] (CC#89)
Selects the LFO waveform.
2. Mode [Tempo, Free, One Shot]
Specifies whether the LFO cycle is synchronized to the tempo or MIDI clock.
Tem po: The LFO cycle is synchronized to the tempo or MIDI clock. When Clock Source on the MIDI
page in Global (MIDI clock settings) is set to “Internal”, the LFO synchronizes to the tempo that’s set
by the Tempo parameter. When the value is set to “External MIDI/USB”, the LFO synchronizes to MIDI
clocks received from an external MIDI device. When the parameter is set to “Auto”, the LFO synchro-
nizes to MIDI clocks from an external MIDI device only if they are available.
Free: The LFO cycle is not synchronized to the tempo, and instead repeats at the rate set by Fre-
quency.
One Shot: The LFO cycle is not synchronized to the tempo, and is instead output for one cycle only at
the rate set by Frequency.
To Next Page
Loading...
