microKORG2 EFFECT, EQ section - Modulation (MOD)
97
Modulation (MOD)
The modulation effect applies various types of cyclic change to the original sound. This gives the
sound greater depth, or produces the impression that multiple sound sources are being heard simul-
taneously.
You can use modulation effects, a compressor, amp simulator and so on.
•
Press the MOD button while holding down the ON/OFF button to turn the effects on/off (the LED below the
button lights up when the effect is on).
•
Press the MOD button to access the related parameters (the button blinks). Use the EDIT CONTROL 1–5
knobs and the FUNCTION 1, 2 buttons to set the value.
•
Long-press either the MOD, DELAY or REVERB button to access the EFFECT ROUTING page, where you
can set the effect to which each timbre and the mic audio is sent.
→ EFFECT ROUTING
•
Use the Effect Type parameter (knob 1) to select the effect type. The parameters shown below (knobs 2–5)
depend on the effect type.
|
MOD
1. Effect Type (Type) [Chorus, Flanger, Ensemble, Phaser, Tremolo, LoFi, Comp, Distortion, Amp Simu-
lator]
Selects the effect type.
2...5. Effect Parameters
This configures the parameters of each effect.
For more on the parameters, refer to the explanations for each effect type.
|
MOD EXTRA
1...5. Effect Parameters
This configures the parameters of each effect.
For more on the parameters, refer to the explanations for each effect type.
To Next Page
Loading...
