Korg microKORG2 - Pitch

microKORG2 TIMBRE EDIT section - VOICE, PITCH, ASSIGN
53
| PITCH
This sets the pitch of the oscillators. Set the Transpose and Fine Tune to produce the desired pitch.
These settings are shared by all three oscillators. You can also set the portamento time and the
amount of pitch change that’s caused by the [PITCH] wheel.
1. Portamento Time (PortaTime) [0...127] (CC#5)
Adjusts the speed of the portamento effect. Portamento is a smooth change in pitch from one note to
another.
With a setting of 0, the portamento effect is not applied. Larger values cause the pitch to change over
a longer time.
2. Portamento Mode (PortaMode) [Fingered, Always] (CC#65)
Sets how the portamento effect is applied when you press a key.
Fingered: The portamento effect is only be applied to notes played while a key is being held.
Always: The portamento effect is always applied to the notes you play, regardless of whether you
hold down the previous notes.
3. Transpose [-24...0...24] (CC#35)
Adjusts the pitch of the oscillator in half tones (100-cent) steps. The range is two octaves upward or
downward.
4. Fine Tune [-50...0...+50 Cent] (CC#36)
Sets the pitch of the oscillator in one-cent steps. The range is 50 cents upward or downward (±50
cents).
5. Pitch Bend Range (PB Range) [-24...0...24]
Specifies the amount of pitch change in semitones that occurs when you use the pitch bend.