microKORG2 TIMBRE EDIT section - VOICE, PITCH, ASSIGN
52
Mono Retrigger: The sound plays monophonically. Only one sound for the timbre can be played at a
time. The EG and LFO are retriggered each time you press a key.
3. Unison Number (Unison) [Off, 2 Voice...8 Voice]
Specifies the number of voices that will sound for each note you play. When this is off, voices will not
sound in unison, and “Unison Detune” and “Unison Spread” cannot be applied. You can make up to
eight voices play in unison.
Note:
The maximum value is 8 when Timbre Mode is “Single”, and the maximum value is 4 when Tim-
bre Mode is “Dual”.
4. Unison Detune (U.Detune) [0...127] (CC#33)
Specifies how much the individual notes that sound at the same time are detuned when played in uni-
son.
The number of voices set in Unison Number are uniformly assigned to play at the same time, detuned
by the amount you set here.
5. Unison Spread (U.Spread) [0...127] (CC#34)
Widens the panpot (stereo position) settings for the individual notes that sound at the same time
when played in unison.
To Next Page
Loading...
