microKORG2 VOCAL PROCESSOR section - HARD TUNE
92
HARD TUNE
• Press the HARD TUNE button while holding down the ON/OFF button to turn the effect on/off (the
LED below the button lights up when the effect is on).
• Press the HARD TUNE button to show the related parameters (the button blinks). Use the EDIT
CONTROL 1–5 knobs and the FUNCTION 1, 2 buttons to set the value.
• Long-press the VOCODER, HARD TUNE or HARMONIZER button to access the VOCAL SETTING
page, where you can choose whether to correct the pitch according to the scale or the keyboard.
→ VOCAL SETTING
|
HARD TUNE
This effect is for adjusting or correcting the vocal pitch.
Use this to create robot-like voices, or to adjust the formant for a thicker, lower vocal sound or for a
thinner, higher sound.
1. Intensity [0...127] (NRPN 6, 1)
Adjusts the amount of hard tune effect that’s applied.
When the value is “0”, no hard tune is applied. Set this to a larger value when you want to create a
stronger hard tune effect with pitch correction.
2. Speed [0...127] (NRPN 6, 2)
Sets the speed of pitch correction.
When this is set to “0”, the pitch is corrected instantly. Larger values slow down the pitch correction
time.
3. Formant [-63...0...63] (NRPN 6, 3)
Adjusts the formant to change the vocal character.
This lets you change the vocal input signal into a thick, low voice (negative values) or into a thin, high
voice (positive values).
To Next Page
Loading...
